STIHL MS 261 C-M Bedienerhandbuch PDF herunterladen (Seite 41)

MS 261 C-M

English

39

Adjustable flow oil pump is a special

option.

Different quantities of oil are required for

different bar lengths, types of wood and

cutting techniques.

Use the adjusting screw (1) (on

underside of machine) to vary the oil

feed rate as required.

Ematic position (E), medium oil flow rate

–

N turn the adjusting screw to "E"

(Ematic position).

To increase oil feed –

N turn the adjusting screw clockwise.

Turn reduce oil feed –

N turn the adjusting screw

counterclockwise.

NOTICE

The chain must always be wetted with a

film of lubricant.

N Turn the guide bar over – every time

you sharpen the chain and every

time you replace the chain – this

helps avoid one-sided wear,

especially at the nose and

underside of the bar.

N Regularly clean the oil inlet hole (1),

the oilway (2) and the bar groove

(3).

N Measure the groove depth – with the

scale on the filing gauge (special

accessory) – in the area used most

for cutting.

If groove depth is less than specified:

N Replace the guide bar.

The drive link tangs will otherwise

scrape along the bottom of the groove –

the cutters and tie straps will not ride on

the bar rails.

Oil Quantity Control

001BA157 KN

1

Taking Care of the Guide Bar

2

3

1

143BA026 KN

Chain

type

Chain pitch Minimum

groove depth

Picco 1/4" P 0.16" (4.0 mm)

Rapid 1/4" 0.16" (4.0 mm)

Picco 3/8" P 0.20" (5.0 mm)

Rapid 3/8"; 0.325" 0.24" (6.0 mm)

Rapid 0.404" 0.28" (7.0 mm)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 123 124

Kommentare zu diesen Handbüchern

Keine Kommentare