STIHL Chainsaw MS 170 Bedienungsanleitung PDF herunterladen (Seite 37)

MS 170, MS 170 C, MS 180, MS 180 C

English

35

Adjusting the Master Control lever

To adjust the Master Control lever from

run F to cold start l, press and hold

down the throttle trigger lockout and

throttle trigger simultaneously – set

master control lever.

To set the master control lever to warm

start n, first set it to cold start l, then

push the master control lever into the

warm start n position.

Switching to the warm start n position

is only possible from the cold start l

position.

Simultaneously pressing the throttle

trigger lockout and blipping the throttle

trigger causes the master control lever

to jump from the warm start n position

to run F.

To switch off the engine, set the master

control lever to Stop 0.

Position cold start l

– if the engine is cold

– if the engine stalls during opening of

throttle after starting

– If the fuel tank has run empty

(engine stalled out)

Position warm start n

– if engine is warm (once the engine

has been running for approx. one

minute)

– When the engine has turned over

for the first time

– After ventilation of the combustion

chamber, if the engine was flooded

Holding the chain saw

There are two ways to hold the chain

saw during starting.

On the ground

N Place the chain saw securely on the

ground and assume a steady

stance – the saw chain must not

touch any objects and also must not

touch the ground

N With the left hand on handlebar,

press the chain saw firmly against

the ground – thumb wrapped

around the handlebar

N Place your right foot through the

rear handle

Between the knees or thighs

N Clamp the rear handle between the

knees or thighs

N Grip the handlebar firmly with the

left hand – thumb wrapped around

the handlebar

143BA018 KN

143BA019 KN

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 131 132

Kommentare zu diesen Handbüchern

Keine Kommentare